This industrial linear potentiometer has 75mm of travel and connects to an analog input.
The KTC series linear potentiometer is designed to provide position feedback for systems with moving parts. This potentiometer can extend to a length of 75mm and is protected by an anodized aluminium outer casing.
This sensor can be used with any device with an analog input. Simply cut and connect a 3-wire sensor cable as described in the connection section below.
This sensor connects to any device with an Analog Input.
You can use an analog sensor cable to connect the potentiometer to your Phidget. Just snip off the connector from one end of the sensor cable, strip the ends of the wires and connect them using the screw terminals as shown in the diagram below.
|Sensor Type||Input (Linear)|
|Linear Travel||75 mm|
|Potentiometer Impedance||5 kΩ|
|Repeatability Error Max||0.02 %|
|Lifespan||100 million actuations|
- 2 Mounting Brackets
- A Wiring Harness with Cap
- A Rubber Seal
- A Ball Joint Attachment
- 4 Mounting Screws